Tuesday, September 27, 2016
Samsung E2530 Vibrating after direct unlock solution by z3x
Samsung E2530 Vibrating after direct unlock solution by z3x
The following guideline is the solution to Samsung E2530 which keeps vibrating after direct unlock.
1. Download FlashTool_E2_R6 from HERE
2. Download firmware E2530XXKE3_SFRKF1 from HERE
3. Extract both Zip files and run FlashTool_E2.exe application.
4. Add the extracted firmware files (these will be 4 files)
5. Make sure the sorting order is as shown in the picture
6. Make sure "Erase whole flash before Downloading" is selected
7. Click on Start (If it ask you something about COM PORT, just click YES)
8. A new window will pop up.
-------------
9. In new window, click on START USB1
10. Connect turned off phone to USB Cable
11. The flashing will start, will take a little while.
12. When flashing is done, the bar will turn green on sucess
13. Turn on your phone normally afterards.
Note: If the phone bricked during direct unlock, you will not need to unlock it again.
1. Download FlashTool_E2_R6 from HERE
2. Download firmware E2530XXKE3_SFRKF1 from HERE
3. Extract both Zip files and run FlashTool_E2.exe application.
4. Add the extracted firmware files (these will be 4 files)
5. Make sure the sorting order is as shown in the picture
6. Make sure "Erase whole flash before Downloading" is selected
7. Click on Start (If it ask you something about COM PORT, just click YES)
8. A new window will pop up.
-------------
9. In new window, click on START USB1
10. Connect turned off phone to USB Cable
11. The flashing will start, will take a little while.
12. When flashing is done, the bar will turn green on sucess
13. Turn on your phone normally afterards.
Note: If the phone bricked during direct unlock, you will not need to unlock it again.
Go to link download
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment